Need help?Do you have a question about the golmar TEKNA-S GTWIN and is the answer not in the manual?
Lists manual sections and page numbers for navigation.
Crucial safety guidelines for installation and operation.
Details operational flow for calls, communication, and door opening.
Explains the function of each connection terminal (CN1, CN2).
Details the functions of buttons A, B, C, and G on the monitor.
Explains how the monitor supports hearing aids via T-mode.
Describes the information present on the monitor's identification label.
Explains how to use the SW1 switch for user code address assignment.
Explains how to configure the monitor as master/slave using the SW2 switch.
Describes the installation of the EL-566 In/Out unit and J2 jumper.
Specifies the recommended height and clearance for the wall mounting connector.
Instructions for drilling and securing the wall mounting connector to the wall.
Steps to connect cables and attach the monitor to the wall mounting connector.
Specifies the recommended height and clearance for the embedding box.
Instructions for embedding the box and fitting the wall mounting connector.
Steps to connect cables and attach the monitor to the wall mounting connector.
How to adjust call volume (max, min, no volume) using button A.
How to select the door panel ringtone melody using button B.
How to select the apartment front door ringtone using button C.
How to activate/deactivate the doctor mode for automatic lock release.
How to exit the advanced programming mode using button B.
Steps to program a monitor to call another apartment using buttons.
Steps to program a monitor to call another monitor in the same apartment.
Procedure to cancel programmed intercom call codes.
Explains how to connect a button for apartment front door calls.
Details the SAV-GTWIN call repeater and its configuration.
Describes the connection of the SAR-12/18 relay unit.
Explains how to connect multiple monitors/telephones in parallel using a distributor.
To Next Page
General
