Need help?Do you have a question about the Gonset G-66 and is the answer not in the manual?
Specifies reception modes like AM, CW, and SSB.
Lists the frequency bands the receiver can tune.
Defines the minimum signal level for reception.
Indicates the receiver's ability to separate signals.
Details unwanted signal responses, including image.
Lists the IF frequencies used in the receiver.
Specifies impedance for speaker and headphones.
Details antenna connection types and impedance matching.
Outlines voltage and current needs for operation.
States maximum audio power and distortion levels.
Provides the physical weight of the receiver.
Lists tubes and their roles in the receiver circuit.
Details specifications for associated power supplies.
Instructions for physically securing the receiver.
Guidance on connecting antennas for optimal performance.
Procedures for connecting audio output speakers.
Steps for connecting the receiver to a power source.
Describes the receiver muting function for transmission.
Explains using receiver power for VFO spotting.
Advice on minimizing automotive electrical noise interference.
How to use the function switch and volume control.
Guidance on tuning frequencies and using the calibration trimmer.
How to adjust the Beat Frequency Oscillator for SSB/CW.
How to adjust the antenna trimmer for signal optimization.
Explanation of the S meter's function and adjustment.
Tips for using the receiver on the broadcast band.
Recommendations for lubricating mechanical parts.
Common causes of malfunctioning, focusing on tubes.
Step-by-step guide for receiver alignment.
To Next Page
General