GOODEE W80 - Page 14

Steps to Connect through Charging Cable
—
For Android Phone (Android system)
Connect through device configuration if you choose not fo the use the App.
Step 1. Tum on fhe projector and press the “S” key o select Screen Miroring as fhe input source.
Step 2. Go fo fhe “Seflings” on your device, find “Developer Opfions” and fum on the “UsB Debugging.”
Nofe: The steps fo fum on “Developer Options” may vary among Android devices. Please contact our
customer service if you have questions about this step.
Exomple: Samsung Golaxy S8+
Go to the "Setiings"” and follow About Phone—Sofftware Information—Build Number. Tap “Build Number”
for several fimes unti f shows “Developer mode had been fumed on". Go back to fhe "Settings" and it
should show “Developer Opfions” now.
Step 3. Connect your Android mobile device 10 fhe USB-T port of the projector with he original charging
cable.
Step 4. Select “OK" in fhe pop-up windows of *Allow USB debugging?”. Your device's screen should be
projected fo the wall/screen n a few seconds.
Allow USB debugging? Allow USB debugging?
USB debugging is intended for development The computer's RSA key fingerprint s
purposes only.lt can beused to copy data 9D:BF :CE:3E:80:D7:12:89:2A'6E:1D:
between your computer and your device, 2074553478
install application,and log data. Py
© Aways allow from this computer
CANCEL CANCEL
Please note:
a. The charging cable must be the original cable or a compatible cable, or the screen mirroring may be
unsuccessful.
b. Some mobile devices may not support screen miofing.
|En13)