EasyManua.ls Logo

Goodman GMH81155CN Series User Manual

Goodman GMH81155CN Series
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
C
US
®
RT6621014 Rev. 2
June 2009
Copyright ©2006 - 2009 Goodman Manufacturing Company, L.P.
This manual is to be used by qualified, professionally trained HVAC technicians only.
Goodman does not assume any responsibility for property damage or personal
injury due to improper service procedures or services performed by an unqualified
person.
Refer to Service Manual RS6610004 for installation, operation, and troubleshooting information.
All safety information must be followed as provided in the Service Manual.
Refer to the appropriate Parts Catalog for part number information.
Model numbers listed on page 3.
GMH8 39" 80% Gas Furnace
80% AFUE, 2-Stage (Convertible),
Multi-Speed, Upflow/Horizontal
TECHNICAL MANUTECHNICAL MANU
TECHNICAL MANUTECHNICAL MANU
TECHNICAL MANU
ALAL
ALAL
AL
Question and Answer IconNeed help?

Do you have a question about the Goodman GMH81155CN Series and is the answer not in the manual?

Goodman GMH81155CN Series Specifications

General IconGeneral
ModelGMH81155CN Series
Fuel TypeNatural Gas
ConfigurationUpflow/Horizontal
Ignition TypeHot Surface Ignition
Gas ValveSingle Stage
Weight130 lbs

Summary

PRODUCT IDENTIFICATION

PRODUCT DESIGN

General Operation

Details the furnace's electronic ignition, induced draft blower, self-diagnosing control module, and heating capacity calculation.

Location Considerations

Covers optimal furnace placement, clearances from combustibles, and specific requirements for garage installations.

PRODUCT DESIGN

Accessibility Clearances (Minimum)

Specifies minimum required clearances to combustible materials for servicing and general access.

High Altitude Derate

Explains the necessity of high altitude orifice kits and derating for correct operation above 2000 feet.

COMPONENT IDENTIFICATION

Upflow/Horizontal

Identifies key internal components of the furnace, referencing a diagram with numbered parts for upflow/horizontal configurations.

PRODUCT DIMENSIONS

PRODUCT DESIGN

PRESSURE SWITCH TRIP POINTS AND USAGE CHART

Lists pressure switch trip points and corresponding part numbers for square and round nose types across various models.

T.O.D. PRIMARY LIMIT

Provides part numbers and opening temperature settings for primary limit switches for different furnace models.

ROLLOUT LIMIT SWITCHES

Details part numbers and open settings for rollout limit switches, listed by furnace model.

AUXILIARY LIMIT SWITCHES

Lists part numbers and open settings for auxiliary limit switches, correlating with specific furnace models.

PRODUCT DESIGN

Coil Matches

Describes compatible Goodman brand indoor coils for GDH8 furnaces using R22 and R-410A refrigerants.

PRODUCT DESIGN

Thermostats

Indicates that detailed thermostat information is available in separate specification sheets.

Filters

Outlines filter requirements, compliance standards, and the impact of missing filters on the unit warranty.

Upflow Filters

Details the furnace's provisions for return air filters at side/bottom, including sizes and flow areas.

MINIMUM FILTER SIZES

Presents a table of minimum filter sizes and required area based on furnace input and filter type.

PRODUCT DESIGN

Dual $aver Configuration & Operation

Explains the furnace's heating modes and how to adjust dipswitches for single-stage or modified two-stage operation.

FURNACE SPECIFICATIONS

BLOWER PERFORMANCE SPECIFICATIONS

BLOWER PERFORMANCE SPECIFICATIONS

WIRING DIAGRAMS

SCHEMATICS

TYPICAL SCHEMATIC

Presents a typical schematic diagram for the GMH8 model furnaces with an integrated ignition control.

Related product manuals