WHILE CARBON MONOXIDE DETECTORS DO PROVIDE ADDITIONAL PROTECTION,
CURRENT LIMITATIONS TO THEIR EFFECTIVENESS REQUIRES THAT YOU OTHERWISE
CONTINUE TO FOLLOW APPROPRIATE INSTRUCTIONS LOCATED IN THE "INSTALLATION
& OPERATING INSTRUCTIONS" AND "USERS INFORMATION" MANUALS RELATING TO
PROTECTING PERSONS FROM THE RISKS OF CARBON MONOXIDE. REVIEW EACH CO
DETECTORS MANUFACTURERS' EXPLANATION OF THEIR UNIT'S CAPABILITIES AND
FOLLOW THOSE INSTALLATION AND OPERATING MANUAL WHEN INSTALLING AND
OPERATING THESE UNITS.
WARNING I
THE CIRCULATING AIR DUCTS MUST BE COMPLETELY AND POSITIVALLY SEALED TO I
PREVENT THE COMBUSTION PRODUCTS, INCLUDING CARBON MONOXIDE, FROM I
ENTERING THE LIVING SPACE. I
TO ENSURE PROPER INSTALLATION AND OPERATION OF THIS PRODUCT, COMPLETELY
READ AND UNDERSTAND THESE INSTRUCTIONS PRIOR TO ATTEMPTING TO ASSEMBLE,
INSTALL, MAINTAIN, OR REPAIR. IF THESE INSTRUCTIONS ARE NOT FOLLOWED
PRECISELY THERE IS A POTENTIAL OF CARBON MONOXIDE POISONING, WHICH CAN
RESULT IN SERIOUS ILLNESS OR DEATH.
THIS FURNACE WAS EQUIPPED AT THE FACTORY FOR USE WITH NATURAL GAS ONLY.
LIQUID PETROLEUM (LP) CONVERSION, IF REQUIRED, MUST BE PERFORMED BY A
QUALIFIED TECHNICIAN FAMILIAR WITH PERFORMING THIS TYPE OF CONVERSION. IF
LP CONVERSION IS REQUIRED, ALL INSTRUCTIONS INCLUDED WITH THE FACTORY
AUTHORIZED KIT MUST BE FOLLOWED. THE ONLY KIT THAT MUST BE USED FOR THIS
CONVERSION IS THE FACTORY AUTHORIZED LPM-01. FAILURE TO FOLLOW THOSE
INSTRUCTIONS EXPLICITLY MAY CAUSE FIRE, EXPLOSION, OR PERSONAL AND
PROPERTY DAMAGE.
UNLESS ALLOWED BY LOCAL CODE, DO NOT INSTALL A LIQUID PETROLEUM GAS
BURNING APPLIANCE IN A PIT, BASEMENT, OR SIMILAR LOCATION. LP, A HEAVIER THAN
AIR GAS, CAN COLLECT IN LOW AREAS AND MAY NOT DISPERSE NATURALLY.
APPLIANCES SO FUELED SHALL NOT BE INSTALLED IN AN ABOVE GRADE UNDER
FLOOR SPACE OR BASEMENT UNLESS SUCH LOCATION IS PROVIDED WITH APPROVED
MEANS FOR REMOVAL OF UNBURNED GAS.
I GENERAL INFORMATION I
These Installation and Operating Instructions are intended for use by fully qualified installation
technicians. Some localities require the installer/sevicer to be licensed. If in doubt, check with
local authorities.
INSTALLATION: In the USA this furnace MUST be installed in accordance with the latest edition
of the ANSI Z223.1 booklet entitled "National Fuel Gas Code" (NFPA 54), and the requirements
or codes of the local utility or other authority having jurisdiction. In Canada this furnace must be
IO-151 4
To Next Page
Loading...
