Goodman GMPN060 User Manual

INSTALLATION & OPERATING
INSTRUCTIONS
for GMPN
CONDENSING GAS FURNACE
(CATEGORY IV)
(U.S. PAT. # 5,437,263)
EPA POLLUTION PREVENTER
E FF|CII_NCY
RATING
CERT_FIEO
ama
IF THIS FURNACE IS INSTALLED IN AN ENCLOSED AREA, SUCH AS A GARAGE OR
UTILITY ROOM, EITHER ALONE OR WITH ANY OTHER CARBON MONOXIDE PRODUCING
DEVICE (i.e. ATUOMOBLIE, SPACE HEATER, WATER HEATER, ETC.) INSURE THAT THE
ENCLOSED AREA IS PROPERLY VENTILATED.
WARNING
CARBON MONOXIDE (REFERRED TO AS CO) CAN CAUSE SERIOUS PERSONAL INJURY I
OR DEATH. I
WARN ING I
THIS FURNACE IS DESIGN CERTIFIED FOR INSTALLATION IN BUILDINGS CONSTRUCTED I
ON SITE ONLY. I
Goodman Manufacturing Company, L.P.
IO-151D 1501 Seamist, Houston, Texas 77008 12/01
REPLACEMENT PARTS

Goodman GMPN060 Specifications

General

Fuel Type	Natural Gas
AFUE	80%
Stages	1
Heating Capacity	Up to 60, 000 BTU
Blower Motor Type	Multi-Speed
Gas Valve Type	Single Stage
Heat Exchanger Material	Aluminized Steel
Weight	120 lbs
BTU Output	60, 000 BTU
Ignition Type	Electronic

Summary

General Information

Installation Guidelines

Details furnace installation requirements and compliance with national and local codes.

Location Requirements

Minimum Clearances to Combustible Surfaces

Specifies required distances from furnace to flammable materials for safety.

Venting System

Protection From Freezing

Guidelines for preventing vent and drain system freezing in unheated spaces.

Supporting and Pitching the Vent

Instructions for proper vent pipe installation, support, and pitch for condensate drainage.

Condensate Drain System

Gas Piping and Capacity Table

Information on gas pipe sizing and capacity for correct fuel supply.

Circulating Air Supply and Return Air

Control Voltage Connections

Thermostat Installation

Guidance on thermostat wiring and optimal placement for accurate temperature control.

Setting the Heat Anticipator

Rating the Furnace

Timing the Gas Meter

Main Burner Adjustment

Safety Control Functions and Check-Out Procedure

Safety Switches Overview

Explanation and testing of safety controls like limit, pressure, and flame sensors.

Integrated Fan/Ignition Control

Circulating Air Filters

Minimum Filter Sizes

Specifies the required area and type for air filters for optimal performance.

Temperature Rise Adjustment

Motor Lubrication and Maintenance

Service Instructions

Sequence of Operation

Heating Mode Operation

Step-by-step process of furnace operation during a heating call.

Cooling Mode Operation

Sequence of operation for the furnace when operating in cooling mode.

Removing an Existing Appliance

Inspecting & Cleaning the Heat Exchanger

Source of Combustion Air

Blower Off Delay Setting

Electronic Air Cleaner Control

Humidifier Control Connection

Drain Connections

Lighting Instructions

Operating Instructions