10
Power Limit Solution for Grid-Tied PV Inverters User Manual V1.0-2022-09-15
Step 3 Tap Home > More > Advanced Setting > Power Limit Settings to enter into the parameter setting page.
Step 4 Enter the parameters based on actual needs, tap “√” and the parameters are set successfully.
No. Parameters Description
1 Export/Power Limit
Enable Export/Power Limit when power limiting is required by local grid standards and
requirements.
2 Mode
Select the power limit model according to the applied scenarios under local region and country’s
requirement. The current software is available both for single phase and three phase power limit.
3 Export Power Set the value based on the actual maximum power feed into the utility grid.
4 External CT Ratio Set the ratio of the primary current to the secondary current of the external CT.
5
Export Power Limit
Protection
After enabling this function, the inverter will stop grid tying once the export power limit fails.
3.3 Setting Power Limit Parameters via ProMate
• Already obtained ProMate from the website and installed it in computer;
• Already nished the inverter wiring and power on. No fault has occurred;
• Set power limit parameters via ProMate software when EzLogger Pro or SEC1000 is connected in the system.
Notice
• Before setting any parameters, read through this document and the related inverter’s user manual to learn the product
functions and features. If the inverter parameters are set improperly, operations such as issuing start or stop griding
commands to the inverter may fail or not in compliance with the related requirements, thus aecting the inverter’s power
generation.
• For more details, refer to SEC1000 User Manual. Visit https://en.goodwe.com/Ftp/EN/Downloads/User%20Manual/GW_SEC1000_
User%20Manual-EN.pdf or scan below QR to get the user manual.
• For more details, refer to EzLogger Pro User Manual. Visit https://en.goodwe.com/Ftp/EN/Downloads/User%20Manual/GW_
Ezlogger%20Pro_User%20Manual-EN.pdf or scan below QR to get the user manual.
SEC1000
User Manual
EzLogger Pro
User Manual
Preconditions
Operations