134492
• Panels and furniture lining of the kitchen cabinet receiving
the hob must be treated with temperature resistant adhesives
(100°C), otherwise they might be discoloured or deformed
because of inadequate temperature resistance.
• Before installation you must remove the rear panel from the
kitchen cabinet in the area of installation.
• Follow the exact dimensions of the installation aperture,
indicated on the illustration.
• Bottom of the kitchen cabinet (max 530 mm) must always
be shorter than side panels in order to provide adequate
ventilation.
• Level the kitchen cabinet using the spirit level.
• Kitchen cabinet carrying the installed appliance must be fi xed
to the adjacent cabinet to ensure adequate stability.
• Push the appliance into the cabinet so that screw guides
located in the oven frame holes stay on the cabinet side
panels. Be careful not to tighten the screws excessively
because you may damage the cabinet sides or the enamel of
the appliance.
33
Instalation for electric
oven
To Next Page