Gorenje GV662D60 - User Manual

Questions and Answers

T
taylorhopkinsAug 21, 2025
How to improve cleaning performance of my Gorenje GV662D60 Dishwasher?
- B
  Brandon BarnesAug 21, 2025
  If your Gorenje Dishwasher isn't cleaning dishes properly, start by checking if the spray arms rotate freely and that the dishes aren't blocking them. Remove the spray arms and clean them, paying attention to any blocked holes or bearings. Select a more intensive program for greasy dishes. Ensure correct detergent dosage according to water hardness; using too much or too little can affect results.
J
Jordan RangelAug 23, 2025
How to remove grease deposits in my Gorenje GV662D60?
- T
  Tiffany TaylorAug 25, 2025
  To address grease deposits in your Gorenje Dishwasher, select a high-temperature program like Intensive wash for very dirty dishes, or run the self-cleaning program.
J
James PayneAug 26, 2025
How to prevent spots on stainless steel or silver in Gorenje Dishwasher?
- B
  Brandon ColeAug 26, 2025
  To prevent spots on stainless steel or silver in your Gorenje Dishwasher, rinse off foodstuffs like mustard, mayonnaise, lemon, vinegar, salt, and dressings if you're not starting the dishwasher immediately. Separate dishes made from different metals like silver, stainless steel, and aluminum to avoid contact during washing.
B
brent62Aug 28, 2025
Why does water remain in my Gorenje Dishwasher?
- B
  Barry HebertAug 28, 2025
  To resolve the issue of water remaining in your Gorenje Dishwasher, start by cleaning the coarse and fine filters. Ensure the filter handle is locked in the stop position. Additionally, inspect the drainage pump for debris and clean it if necessary. Check that the colored stop on the right in the bottom drain is in place. Also, make sure the drainage hose is free from kinks and sharp bends. Finally, disconnect the drainage hose from the sink unit's water trap to check for blockages, ensuring the connection has an inner diameter of at least 14 mm.
J
Jody PotterAug 30, 2025
Why are there spots or films on the dishes from my Gorenje GV662D60?
- L
  laura21Aug 30, 2025
  If your Gorenje dishwasher leaves spots or films on the dishes, it could be due to several reasons: the water softener might be leaking salt (check the compartment lid), the water softener or rinse aid dosage might be incorrectly set, or the salt compartment might be empty (top it up). If you're using 3-in-1 detergent with the TAB setting activated, try inactivating the setting and adding salt and rinse aid separately. High temperatures or too much detergent can also cause etching on crystal; wash crystal at a lower temperature with less detergent.
S
susan11Sep 1, 2025
How to fix Gorenje Dishwasher if the dishes are not dry enough?
- K
  Kevin MartinSep 1, 2025
  If your Gorenje Dishwasher leaves dishes not dry enough, activate the Auto open option. Make sure you fully load the dishwasher. Check and top up the rinse aid or increase its dosage. If you are using a 3-in-1 detergent and the TAB setting is activated, try inactivating the TAB setting and top up salt and rinse aid separately.
S
Sara ChavezSep 3, 2025
Why Gorenje Dishwasher buttons do not react when pressed?
- B
  baxterkimSep 3, 2025
  To address the issue of buttons not reacting on your Gorenje Dishwasher, wait a moment before pressing them after opening the door. Ensure the buttons are clean using a dry or slightly damp cloth. The buttons are designed to work only when the door is open. Also, verify that the baskets are correctly positioned horizontally and that dishes aren't obstructing the baskets from sliding into place.
B
Brandi HollandSep 5, 2025
How to get rid of bad odour in Gorenje GV662D60 Dishwasher?
- W
  walterskyleSep 5, 2025
  If your Gorenje Dishwasher has a bad odor, clean around the seals and in the corners with a washing-up brush and a low-foaming cleaner. If you've been using low-temperature programs for a long time, run a higher temperature program about once a month or select the self-cleaning program.
A
Alex LaneSep 7, 2025
What to do if my Gorenje Dishwasher is overfilling?
- B
  Brian CoxSep 7, 2025
  If your Gorenje Dishwasher is overfilling, clear the drainage pump.
D
Daniel RomeroSep 9, 2025
What to do if my Gorenje Dishwasher shows a water inlet fault?
- P
  paul00Sep 9, 2025
  To resolve a water inlet fault in your Gorenje Dishwasher, check that the water tap is on and that the outer filter on the inlet hose is not blocked.

Summary

Your dishwasher overview

Safety instructions

General operating safety

Crucial warnings and guidelines for safe use of the appliance.

Before washing for the first time

Water hardness management

Checking and setting water hardness for optimal cleaning performance.

Salt and rinse aid replenishment

Instructions for filling the salt and rinse aid compartments.

Greener dishwashing practices

Dishwasher loading techniques

Basket loading and adjustment

Operating the dishwasher

Detergent and tablet usage

Guidance on adding detergent and using dishwasher tablets correctly.

Program selection and options

Choosing wash programs and utilizing extra features.

Starting, monitoring, and interruptions

Program completion and unloading

Troubleshooting guide

Clearing blockages

Steps to resolve issues with drainage and inlet filters.

Error code and display issues

Identifying and fixing error codes and display problems.

Operational and cleaning problems

Resolving startup failures, dirty dishes, spots, and residues.

Noise, odor, and drying performance

Installation

Electrical connection requirements

Gorenje GV662D60 Specifications

General

Built-in display	Yes
Inlet hose length	1.5 m
Cord length	1.5 m
Noise emission class	B
Noise level	42 dB
Number of washing programs	6
Delayed start timer	Yes
AquaStop function	Yes
Energy efficiency class	C
Width	598 mm
Weight	35.5 kg
Drying Efficiency Class	A
Delay Start	Yes
Half Load Option	Yes
Product size	60 cm
Number of place settings	16 place settings
Programs	Intensive, Auto, Eco, Glass