Programming the Alarm
The remote transmitter supplied is randomly coded with one of over 500,000
different code sequences. After wiring is completed, you are now able to
program the alarm unit with your transmitter’s individual code.
STEP 1
Connect the power to the alarm. The alarm is ready to accept programming of
up to 3 transmitters.
STEP 2
After connecting the power to the alarm, push button on each of the transmitters
you wish to use. ( This must be done within 10 seconds from programming the first
remote.) After 10 seconds the alarm will exit the programming mode.
Programming a Second or Third Transmitter
In order to program an optional second and third transmitter, you must first
disconnect the power from your cycle alarm and then reconnect it. This clears
the alarm of all pre-coded information.
Now press the button on your first remote transmitter until the alarm gives you
a confirmation chirp. Within 5 seconds of programming the first transmitter,
press button of your second and third transmitter until you hear a confirma-
tion chirp. Transmitter programming is now complete.
To Next Page
Loading...