1. Rotate Prop Stick to ensure that reflectors remain open.
2. Fill Tube with desired liquid. Fill to just under the top line
of inner coating.
3. Remove Silicone Cap from Tray Handle
4. Place Silicone Cap onto the mouth of the Tube
5. Place or mount, orienting towards the Sun (p. 16)
• Always Fill to Fill Line. Under-filling causes the Tube
to heat unevenly and creates the risk of flash steam
when pouring.
• Use Caution When Pouring Hot Liquids. Pouring too
quickly may cause hot liquids to rapidly pour out of
Tube, increasing risk of burn-related injury.
WARNING
Top of
Inner Coating
Fill Line
8
BOILING MODE
HEAT LIQUIDS
To Next Page
Loading...
