8
9
Projector Setup
Charging the Battery
Connect the included charging cable to the DC Power Input on the projector and a standard power outlet. The
Charging Indicator will turn red while charging and it will switch to green when fully charged. Total charging time is
approximately 7 hours.
Switch the Power Switch to the ON position, then press the Power button to turn the projector ON or OFF. Battery life
is approximately 3 hours when at 50% Brightness/volume level. This unit has a Main Power Switch, which gives the
unit power and puts the unit in standby. When powered ON and in standby mode the battery will last approximately
5 hours.
ONOFF
Main Power Switch
Please make sure to flip this switch to the
ON position to power the unit.
NOTE: THE BATTERY INDICATOR
WILL FLASH WHEN THE
BATTERY IS LOW, PLEASE
RECHARGE.
Image Adjustment
Keystone Adjustment
For Keystone Correction, press the
OK
1 23
456
789
0
SOURCE
GOTO
ZOOM/WIDE
MENU
FLIP VOL –VOL +
EXIT
buttons on
the remote.
You can also adjust Keystone Correction by pressing
the Menu button on the remote, going to the Options
Menu and selecting Keystone Correction. Use the
Up and Down Arrow buttons to manually adjust the
Keystone Correction.
Focus Adjustment
Increase or reduce image size to sharpen image.
Removing the Lens Cap
Please remember to remove the lens cap before attempting to view media.
Putting Lens Cap On
1. When putting the lens cap back on, please make sure that you retract the lens back
into the projector to avoid damaging the lens . You can do this by:
ONOFF
IR
1. Orient the projector with the lens facing you, as shown below.
2. Scroll the focus ring all the way to the left. Once the lens is fully retracted back
inside, you may then place the lens cover back on.
To Next Page
Loading...
Need help?
General
