To Next PageTo Next PageWhat to do if my Graco 210ES 261830 motor won't operate?
If the Graco Paint Sprayer motor won't operate, gradually increase the pressure setting to see if the motor starts. Also, the spray tip or fluid filter may be clogged, so relieve the pressure and clear any clogs or clean the gun filter.
Why won't the motor on my Graco 210ES 261830 operate?
If the Graco Paint Sprayer motor won't operate and you suspect the pump is frozen due to water or water-based paint, thaw the sprayer by placing it in a warm area. Ensure it is completely thawed before starting. If the paint has hardened, you will need to replace the pump packings.
What to do if the displacement pump connecting rod pin is the cause of my Graco Paint Sprayer motor not operating?
If the motor on your Graco Paint Sprayer won’t operate, check the displacement pump connecting rod pin. Push the pin into place and secure it with the spring retainer.
General| Maximum Pressure | 3000 PSI |
|---|---|
| Hose Length | 50 feet |
| Power Source | Electric |
| Spray Pattern | Adjustable |
| Amperage | 15A |
Essential safety guidelines for operating the equipment.
List of additional manuals for related products or services.
Precautions to prevent ignition of flammable fumes and vapors.
Risks associated with specific solvents and pressurized aluminum components.
Warnings about hot equipment surfaces during operation.
Hazards related to moving components and pinch points.
Dangers from exposure to hazardous fluids or fumes.
Requirements for protective gear to prevent injury.
Guidelines for safe electrical connection and grounding procedures.
Steps to safely release pressure before maintenance or storage.
Diagnosing and resolving problems with motor startup and function.
Troubleshooting low pressure, inconsistent output, or no output.
Identifying and fixing electrical faults and mechanical issues.
Resolving issues where motor runs but pump does not stroke or vice versa.
Instructions for removing and installing the displacement pump.
Steps for replacing the drive housing assembly.
Guide for replacing worn motor brushes.
Instructions for removing and installing the control board.
Procedure for replacing a blown fuse on the control board.
Steps for removing and installing the pressure control assembly.
Steps for removing and installing the motor on the Hi-Cart model.
Steps for removing and installing the motor on the Stand model.
Schematic illustrating electrical connections for 120V operation.
List of components and their part numbers for the Hi-Cart model.
List of components and their part numbers for the Stand model.
