7309368
PRESSURE RELIEF
Follow these instructions whenever you are instructed to relieve pres-
sure, stop spraying for more than 10 minutes, check or service the
equipment, or install or clean the spray nozzle.
1. Engage trigger safety latch.
2. Turn pressure washer off.
3. Remove ignition cable from spark plug.
4. Shut off water supply. Disconnect from water.
5. Disengage trigger safety latch and trigger the gun to
relieve pressure. Then re--engage the safety latch.
Note: If you suspect that the spray tip or hose is clogged or that pressure has not been fully relieved after
following the steps above, disengage the trigger safety latch and trigger the gun to relieve pressure.
To Next Page
Loading...
