39
Rear Facing
with Seat Belt
3-C
9. Tighten the Vehicle Seat Belt
Press down firmly in the center of the car seat.
Pull on the shoulder belt to tighten while feeding
the slack back in the retractor. Do not pull on the
strap with excessive force.
10. Close the SnugLock
®
Lock-Off
When the slack is removed, close the SnugLock
®
Lock-Off until you hear a “Click”. Make sure the
vehicle seat belt is under the SnugLock
®
Lock-Off.
Note: When using the lock-off, you are not
required to switch the retractor as an installation
step. The lock-off locks the seat belt. However,
it is recommended to switch the retractor after
the installation is complete to avoid a possible
strangulation risk.
Keep hands away from the lock-off
area when closing the lock-off.
CLICK!
To Next Page