Graco 65 - REAR-FACING INSTALLATION WITH LATCH

16
REAR-FACING INSTALLATION WITH LATCH
Adjust child restraint to recline position
(fig. a). Flip recline feet under child
restraint for rear facing use.
-AKESURE&ORWARD&ACINGLATCH belt is
stored. (see fig. c, pg. 37)
Place rear-facing ONVEHICLESEATEQUIPPED
with LATCH anchors.
For ease of installation, extend LATCH belt
to its maximum length.
(OOKCONNECTORSTOVEHICLELOWERANCHORS
(fig. b). Belt must lay flat and not be
twisted. Pull connectors to be sure they
are securely attached to the anchor points.
(fig. c).
0RESSDOWNlRMLYINCENTEROFCHILDRESTRAINT
while pulling LATCH adjustment belt. (fig. d).
0ULLFRONTTOBACKANDLEFTTORIGHTATBELTPATH
TOCHECKFORSECUREINSTALLATION(fig. e).
1
2
3
4
#HECKTHATTHELOWERANCHORBELTSTAYSTIGHT
and does not slip from the tightened position. If
it does not stay tight, try another seating
POSITIONORCONTACT#USTOMER3ERVICE
#HECKLEVELINDICATORONCHILDRESTRAINT(fig. f).
Vehicle mustBEONLEVELGROUNDANDCHILDIN
CHILDRESTRAINTWHENCHECKINGLEVELINDICATOR
Ball MUST be entirely in green zone (fig. f). If
necessary, place rolled towels under child
RESTRAINTATVEHICLESEATCREASEUNTILENTIREBALL
ISINGREENZONE4HENRECHECKLEVELINDICATOR
7
5
6
DO NOT use tether rear-facing4ETHERmust be
STOREDSEEh4ETHER3TORAGEvPAGE
 0ERIODICALLYCHECKTHATCHILDRESTRAINTISSECURELY
INSTALLEDANDPROPERLYLEVELEDADJUSTIFNECESSARY
 4OREMOVE LATCHSEEh2EMOVINGLATCH from
 6EHICLE!NCHOR0OINTSvP