Graco 65 - FORWARD-FACING INSTALLATION WITH LATCH

18
FORWARD-FACING INSTALLATION WITH LATCH
Adjust child restraint to Upright position
(fig. a). Flip recline feet out for
forward facing use.
-AKESURE2EAR&ACINGLATCH belt is
stored. (see fig. b, pg. 37)
Place
forward-facing ONVEHICLESEAT
EQUIPPEDWITHLATCH anchors.
For ease of installation, extend LATCH
belt to its maximum length.
(OOKCONNECTORSTOVEHICLELOWER
anchors (fig. b). Belt must lay flat and
not be twisted. Pull connectors to be
sure they are securely attached (fig. c).
3LIDECHILDRESTRAINTBACKUNTILTHE
RESTRAINTISINCONTACTWITHTHEVEHICLE
SEATBACK
1
2
3
4
5
Press down firmly in center of child restraint to
 COMPRESSVEHICLESEATCUSHIONWHILETIGHTENING
LATCH belt by pulling adjustment belt (fig. d).
 0ULLFRONTTOBACKANDLEFTTORIGHTATBELTPATH
 TOCHECKFORSECUREINSTALLATION(fig. e).
 #HECKTHATTHELOWERANCHORBELTSTAYSTIGHT
and does not slip from the tightened position.
If it does not stay tight, try another seating
 POSITIONORCONTACT#USTOMER3ERVICE
6
7
 !TTACHTETHERSTRAPHOOK(A) to anchor
hardware (B) and tighten adjustment belt to
 REMOVEANYSLACK(fig. f).
Belt must lay flat and not be twisted.
 0ERIODICALLYCHECKTHATCHILDRESTRAINTIS
 SECURELYINSTALLEDADJUSTIFNECESSARY
8
 4OREMOVE LATCHSEEh2EMOVINGLATCH from
 6EHICLE!NCHOR0OINTSvP