Graco 65 - FORWARD-FACING INSTALLATION WITH VEHICLE SEAT BELTS

22
0RESSDOWNlRMLYINCENTEROFCHILD
RESTRAINTTOCOMPRESSVEHICLESEAT
CUSHIONWHILETIGHTENINGVEHICLESEAT
belt (fig. d).
0ULLFRONTTOBACKANDLEFTTORIGHTAT
BELTPATHTOCHECKFORSECURE
installation (fig. e). Vehicle lap belt
MUST stay tight. If not secure, see
h6EHICLE3EAT"ELTSvPG
!TTACHTETHERSTRAPHOOK(A) to anchor
hardware (B) and tighten adjustment
BELTTOREMOVEANYSLACK(fig. f). If
VEHICLEDOESNOTHAVEANCHORPOINTSTO
ATTACHTETHERHOOKTETHERHOOKSHOULD
BESTOREDSEEh4ETHER3TORAGEv
page 47. Belt must lay flat and not be
twisted.
0ERIODICALLYCHECKTHATCHILDRESTRAINTIS
SECURELYINSTALLEDADJUSTIFNECESSARY
4
5
6
FORWARD-FACING INSTALLATION
WITH VEHICLE SEAT BELTS
WARNING
LATCH belts MUST be stored when
using vehicle seat belt to install child
restraint.
Store Rear Facing and Forward Facing
LATCH belt as shown. (fig. a).
Adjust car seat to upright position
Flip recline feet out for forward
facing use (fig. b).
Place forward-facing ONVEHICLESEAT
 3LIDECHILDRESTRAINTBACKUNTILTHE
 RESTRAINTISINCONTACTWITHTHEVEHICLE
 SEATBACK
 4HREADVEHICLESEATBELTTHROUGH
 OPENINGSANDBUCKLEBELT(fig. c).
1
2
3
 4OREMOVE LATCHSEEh2EMOVINGLATCH
 FROM6EHICLE!NCHOR0OINTSvP