Lap Belt Installation
Always review your vehicle owner’s manual for specific information about your
vehicle seat belts.
Locking Latch Plate and No
Retractor
When installing the car seat, route the
lap seat belt through the proper path and
buckle it in. Then, pull upwards on the
tail of the belt so that the lap belt gets tight
around the car seat.
Sewn On Latch Plate and ALR
Slowly pull the lap belt all the way out.
Route the vehicle seat lap belt through the
proper belt path and buckle it in. Then, pull
the lap belt tight while feeding all the slack
back into the retractor.
Grab the sides of the seat at the belt
path and slide the seat side-to-side
and front-to-back. The seat should
not move more than 1 inch (2.5 cm).
To Next Page
Loading...
Need help?
General
