Graco Size4Me 70 - FORWARD-FACING INSTALLATION WITH LATCH

20
FORWARD-FACING INSTALLATION WITH LATCH
1. Pull out on handle on front of child restraint (a) and adjust to forward-facing
position 2 or 3 (b)-AKESURErear-facing LATCH belt is stored.
(see fig. b, pg. 37)
5NHOOKTETHERFROMTETHERSTORAGESEE
PAGE
3. Place forward-facing ONVEHICLESEAT
equipped with
LATCH anchors.
For ease of installation, extend LATCH
belt to its maximum length.
4. Attach forward-facing connectors to
VEHICLELOWERANCHORS(c). Belt must lie
flat and not be twisted. Pull connectors
to be sure they are securely attached (d).
3LIDECHILDRESTRAINTBACKUNTILTHE
RESTRAINTISINCONTACTWITHTHEVEHICLE
SEATBACK
0RESSDOWNFIRMLYINCENTEROFCHILD
RESTRAINTTOCOMPRESSVEHICLESEAT
cushion while tightening LATCH belt by
pulling adjustment belt (e).
a
d
c
b
e
CLICK!