23
To remove, squeeze release handle at back of
infant restraint and lift out of base as shown
.
To put infant restraint in base, push infant restraint
down until it clicks into base. Pull up on infant
restraint to be sure it is latched firmly into base.
1. Press handle adjustment buttons on both sides of handle
.
2. Rotate handle until it clicks into any of the
4 positions:
Position A: MUST be used
when carrying by handle,
Position A,B,C,D: may be used in vehicle.
BOTH handle adjustment
buttons must pop out to lock
handle in place .
3. Push and pull on the handle
to be sure it is locked firmly in
position.
Carrying
Sitting
A
C
D
5.1 Adjusting Handle
5.2 Removing and Attaching Infant Restraint
B
To Next Page
Loading...
Need help?
General