EasyManua.ls Logo

Graco SnugRide Click Connect 35 - 7 Using Infant Restraint; Positioning Harness Straps

Graco SnugRide Click Connect 35
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
35
1. Remove infant restraint
from base and rotate handle
down to sitting position.
See “5.1 Adjusting Handle” and
“5.2 Removing and Attaching
Infant Restraint”, page. 23.
2. Place child in seat as shown .
3. Determine which pair of harness slots are even
with or just below your child’s shoulders .
4. If the harness straps must be
adjusted: remove child from infant
restraint and move harness straps
to the proper harness slots by doing
the following:
FAILURE TO PROPERLY ADJUST THE HARNESS STRAPS FOR
YOUR CHILD INCREASES THE RISK OF SERIOUS INJURY OR
DEATH IN THE EVENT OF A SHARP TURN, SUDDEN STOP, OR
CRASH. The harness straps must be properly adjusted to fit your child
according to the following instructions.
7.0 Using Infant Restraint
7.1 Positioning Harness Straps
Use harness slots
even with or just below
child’s shoulders

Table of Contents

Related product manuals