To Next PageTo Next PageWhat to do if the display is not lit and there is no green light on the back of the display module of my Graco XM PFP?
If the display on your Graco Paint Sprayer is not lit and there's no green light on the back of the display module: * Reset main disconnect and breaker if there is no electric power. * Install red jumpers in junction box terminal blocks if voltage jumpers are not installed or configured in the power junction box.
What to do if Pump Test completes without error, but A or B component has more than 750cc of fluid in beaker on my Graco XM PFP Paint Sprayer?
If the Pump Test completes without error, but either the A or B component has more than 750cc of fluid in the beaker for your Graco Paint Sprayer: * Repeat Pump Test with fresh fluid, because air is trapped in fluid due to excessive agitation, circulation, and heat. Fluid is measured by volume when it is compressed under pressure.
What to do if the Purge Controller right indicator does not turn green (Hazardous Location Models) on my Graco Paint Sprayer?
Check purge box for leaks. Make sure all cable glands are tight, sensor and CAN cable glands include a rubber grommet. Verify mounting screws in purge controller are tight. Verify 8 mounting screw for explosion-proof box are tight. Verify door latches are tight and door mounting screws are tight. Verify air regulator to purge controller-mounted in front sprayer air panel) is set to 80 psi. Verify no air blockage to purge controller. Verify flow control valve in purge controller is open. Verify bottom port closest to purge controller output is open.
What to do if the Purge Controller left indicator does not turn green (Hazardous Location Models) on my Graco Paint Sprayer?
Check purge box for leaks. Verify pinch valves in purge controller are all closed except for the 2 min pinch valve. Verify no obstruction on purge enclosure exhaust because there is a Leak in purge box or obstructed purge exhaust.
What to do if both purge controller indicators are green but the display screen does not turn on on my Graco Paint Sprayer?
Verify air line between purge controller (through flame arrestor) and pressure switch in explosion proof box is not obstructed. Verify wiring is secure in explosion proof box between the pressure switch terminals and the contactor. Verify wiring from explosion proof box to purge box (large explosion proof bushing) because there is an obstructed air line or loose wiring.
General| Brand | Graco |
|---|---|
| Model | XM PFP |
| Category | Paint Sprayer |
| Language | English |
