Graef CLASSIC C95 - Page 25

25
DE
EN
FR
NL
IT
ES
DK
SE
NO
PL
UKR
HU
as hotplates, or near them.
● Never use the unit outdoors, and always
keep it in a dry place.
● The unit is not designed for installation in a
wall or a built-in cupboard.
● Do not set up the unit in a hot, wet or moist
environment.
● The socket has to be easily accessible so
that the power cable can be removed eas-
ily in case of emergency.
ELECTRICAL CONNECTION
For safe and fault-free operation of the unit,
the following requirements have to be met
during the electrical connection:
● Before connecting the unit, compare the
connecting data (voltage and frequency)
on the type plate with those of your energy
network. These details must correspond so
that no damage occurs to the unit. In case
of uncertainty, contact a qualified electri-
cian.
● The socket has to be protected at least by
a 10 amps circuit breaker.
● Make sure that the connecting cable is not
damaged and not laid across hot surfaces
or sharp edges.
● The connecting cable must not be stretched
tightly.
● The electric safety of the unit is ensured
only when it is connected to a socket with
protective conductor installed correctly.
Operation on a socket without protective
conductor is forbidden. If in doubt, let the
house installation be checked by a skilled
electrician. The manufacturer does not as-
sume responsibility for damage which has
been caused by missing or interrupted pro-
tective conductor.
SOURCES OF DANGER
CAUTION
The very sharp blade can cut off body parts.
Your fingers are especially at risk. For this rea-
son never reach into the space between the
stop plate and blade as long as the stop plate
is not completely closed, i.e. set to below “0“.
TRIGGER GUARD
The unit has a trigger guard to prevent unau-
thorised use. The trigger guard fitted below
the slide is pressed backwards with the finger
without pressing the safety switch button. The
unit can only be switched on when the trigger
guard is unlocked.
SHORTTIME SERVICE
After a short-time operation of 10 minutes, let
the motor cool down for an hour.
SLICING MATERIAL
The unit can be used to cut bread, ham, sau-
sage, cheese, fruit, vegetables, et cetera.
IMPORTANT!
By no means cut hard matter, such as frozen
food, bones, wood, sheet metal, or the like.
COMMISSIONING
● Place the enclosed tray, a plate or similar
under the unit.
● Select the requested cutting thickness.
● Place the slicing material on to the slide.
● Place the combi-attachment / food holder
on the rear wall of the slide and place the
combi-attachment against the slicing mate-
rial.
● Either press the intermittent switch or turn the
knob on the side of the slide to activate the
continuous operation.
IMPORTANT!
The unit must not be used without the com-
bi-attachment / food holder, unless the size
and shape of the slicing material does not
allow its use. As soon as the size and shape
of the slicing material allow the use of the
combi attachment / food holder, it must be
used.
● Press the slicing material slightly against the