26
stop plate with the combi-attachment and
guide the slide evenly towards the blade.
● After completion of the cutting process, re-
lease the intermittent switch or turn the knob
on the side of the slide back to its original
position in order to switch off the device.
IMPORTANT!
Soft slicing material (such as cheese or
ham) can be cut best when chilled. Soft slic-
ing material can be cut better when moved
forward more slowly.
COMBIATTACHMENT AS MINISLICE
● Put the combi-attachment on the slide back
wall.
● Turn the locking lever tightly.
● Put the slicing material, e.g. cucumber, car-
rots, mushrooms, cocktail tomatoes into the
filling shaft.
● ONLY WITH CLASSIC C95: If necessary,
place the insert in the filling shaft. This slides
down automatically. Do not press.
● Set the requested cutting thickness.
● Put a tablet, chopping board or plate un-
der the blade.
● Either press the intermittent switch or turn the
knob on the side of the slide to activate the
continuous operation.
● Evenly move the slide towards the blade.
● Release the intermittent switch or turn the
knob on the side of the slide back to its
original position in order to switch off the
device.
● After completion of the cutting process,
loosen the locking of the combi-attach-
ment.
● After use, clean the combi-attachment.
IMPORTANT!
Frequent cleaning in the dishwasher can
lead to discolouration. Cleaning by hand
under running water is recommended.
30° TILTING (ONLY C95)
The tilting function is particularly suitable for
cutting bread, hard sausages and vegetables.
The tilt function uses the natural gravity of the
slicing material for feeding.
In order to tilt the unit, proceed as follows:
● - Press the lock button. The unit is unlocked.
● Push the unit upwards so that it is tilted 30°.
● To fix the position, push the swivelling lever
upwards.
● The unit is only secured when it audibly
locks into place.
● Now you can continue as described un-
der "Commissioning".
● After completion of the cutting process,
press the swivelling lever down and swivel
the unit back again.
● By pressing on the rear part of the profile,
the locking bolt clicks into place.
CLEANING
Use a soft and moist cloth to clean the outer
surfaces of the unit. Use a mild detergent in
case of heavy contamination.
SLIDE
In order to clean the slide better, it can be re-
moved from the unit.
● Press the slide latch upwards with your fin-
ger.
● Keep the slide latch pressed and pull the
slide towards yourself.
● Use a moist cloth or running water to clean
all parts.
Once a month, please add some drops of
resin-free oil or petroleum jelly to the slide
guide. Use a soft cotton wool cloth to remove
excessive oil / excessive petroleum jelly.
IMPORTANT!
Do not clean the slide in a dishwasher!
To Next Page
Loading...
