Graef CM800 - Cleaning the Grinding Mechanism; Fine Adjustment of the Upper Grinding Mechanism

27
DE
EN
FR
NL
IT
ES
DK
SE
NO
PL
UKR
HU
PUSH
● Turn the grinding ring to the
right as far as possible.
PUSH
● Press the “PUSH” button,
and continue to the grin-
ding ring to the right.
PUSH
● When the two arrows
point at each other
exactly, you can remove
the grinding ring together
with the upper grinding
mechanism. Remove the
upper grinding mecha-
nism from the grinding
ring.
● Clean the lower and upper grinding mechanism with the brush enclosed.
PUSH
● Turn the grinding ring
clockwise to the reques-
ted grinding degree
PUSH
● After cleaning, first of all
place the grinding ring
back on to the motor block
(arrow pointing to arrow).
● Now place the upper
grinding mechanism.
Note: In order to test whether the grinding mechanism has been set in correctly, turn the grin-
ding ring to “coarse”, such as level 35, and try to pull out the grinding mechanism by the metal
ring. If the grinding mechanism cannot be removed, it has been installed correctly.
● Place the coffee bean container on the unit.
FINE ADJUSTMENT OF THE UPPER GRINDING MECHANISM
By means of the fine adjustment of the upper grinding mechanism, you can set the grinding
degree to coarser or finer.
Proceed as follows:
● Remove the upper grinding mechanism.
● Use a screwdriver to remove the small screws.
● Turn the grinding mechanism one stop to the right (coarser) or left (finer).