33
Espresso Machine ES 80 / ES 81
EN
© Gebr. Graef GmbH & Co. KG - 03
■ Do not set up the unit in a hot,
wet or moist environment.
■ The electric socket must be rea-
dily accessible so that the power
cord can be easily unplugged.
Electric connection
Follow these instructions about
the electrical connection for safe
and awless operation of the unit:
■ Before connecting the unit,
compare the connection infor-
mation (voltage and frequency)
on the rating plate with those of
your electrical network. This in-
formation must match to avoid
damage to the unit. If in doubt,
ask your electrician.
■ The socket must be fused with
at least a 10A circuit breaker.
■ Make sure that the power cord
is not damaged. Do not conduct
it over hot surfaces or sharp
edges.
■ The supply cord must not be
pulled tight.
■ The electrical safety of the unit
is only ensured if it is connected
to a properly installed protecti-
ve conductor system. Operation
on a socket without a protecti-
ve conductor is prohibited. If in
doubt, have the building instal-
lation checked by an electrici-
an. The manufacturer does not
assume any responsibility for
damages caused by a missing
or interrupted protective con-
ductor.
Before the rst use
Before using for the rst time or
after a long period of non-use,
you should prepare several cups
of water (without coffee grounds)
to thoroughly ush the system.
Proceed as described in the "Pre-
paring espresso" section.
Setup and Functioning
Features
● Filter support automatic machi-
ne
● Aluminium/stainless steel
housing
● Single thermoblock heater
● Brass lter support
● 360 °C swivelling milk frother/
hot water nozzle
● 2.5 litre water tank
● Freely programmable water vo-
lume
● Freely programmable tempera-
ture
● Water level indicator
● Warming plate for cups
● Removable drip dish
● Double-walled lter insert for
1 cup
● Double-walled lter insert for 2
cups
● Stainless steel milk container
● Coffee spoon
● Cleaning set
To Next Page
