40
Espresso Machine ES 90 / ES 91
EN
Scope of delivery and
shipping inspection
The unit comes standard with the
following components:
● Espresso Machine
● Single-walled sieve insert for 1
cup
● Single-walled sieve insert for 2
cups
● Double-walled sieve insert for
1 cup
● Double-walled sieve insert for
2 cups
● 600 ml stainless steel milk con-
tainer
● Group handle
● Cleaning set
● Coffee spoon, tamper
● Operating instructions
Important!
► Check the delivery for
completeness and for visible
damage.
► Immediately notify the car-
rier, insurance company and
the supplier about an incom-
plete delivery or damages
due to improper packing or
caused by shipping.
Unpacking
To unpack the unit, proceed as
below:
Take the unit out of the carton.
Remove all pieces of the pack-
ing.
Remove all labels from the
unit. (but not the rating plate)!
Dispose the packing
The packing protects the unit
from shipping damage. The pack-
ing materials are selected for their
environmental compatibility and
from disposal aspects; they are
recyclable.
Returning the packing to the
waste disposal system saves raw
materials and reduces the ac-
cumulation of waste. Dispose
packing material that is no longer
needed at a collection point for
the »Green Point« recycling sys-
tem.
Important!
► If possible, save the original
packing during the unit's
warranty period to be able
to properly pack it in case of
a warranty claim.
Requirements for the in-
stallation location
For safe and flawless operation
of the unit, the place of location
must meet these prerequisites:
■ The unit must be set up on a
firm, flat, level, non-slip and
heat resistant base that has suf-
ficient load bearing capacity.
■ Select the place of location so
that children cannot reach the
hot surfaces of the unit.
To Next Page
Loading...
