Graef MS 61 - Making Milk Froth; Warming Up Milk

EN
© Gebr. Graef GmbH & Co. KG - 02
Milk frother MS 61 / MS 62 / MS 80 / MS 85
23
IMPORTANT!
► The froth making process can-
not be manually interrupted.
► If unintended actions were
taken, pull the mains plug
from the electric socket and
lift the tank out of the base
station.
► Let the unit cool off between
uses.
Making milk froth
Connect the unit to the mains
supply:
 Remove the cap and insert the
attachment for warm or cold
milk froth.
 Fill the desired amount of milk
in the tank.
IMPORTANT!
► Comply with the “max”
mark. Never ll any more
milk than that into the tank.
Frothed milk expands; if the
lling level is too high it will
overow the tank.
 Put the cap on the tank.
 Start preparation by press-
ing the corresponding “on”
button. The LED is illuminated
as long as the unit is running.
IMPORTANT!
► Preparation stops automat-
ically after 60 - 90 seconds,
depending on the lling
level.
 Open the cap after preparation
has nished and pull it up.
 Pour or ladle the milk froth into
a cup or glass.
 After using the unit, clean it as
described in the Cleaning and
Care chapter.
Warming up milk
Warming up milk differs from
making milk froth in the following
points:
 Remove the attachment for milk
froth.
 Fill the desired amount of milk in
the stainless steel tank.
IMPORTANT!
► Comply with the "max"
mark. Never ll any more
milk than that into the
tank.
 The rest of the steps are identi-
cal to making warm milk froth.