BATTERY INSTALLATION
2. Close the battery compartment cover.
ASSEMBLING THE CUFF
1. Sit beside the table and let the table support your
arm as you take the measurement. Ensure the cuff
on the upper arm is at approximately the same
level as the heart as shown in Fig.1, and ensure
your feet lie flat on the ground and do not cross.
1. Insert the edge of the cuff approximately
2 in. / 5 cm into the D-ring as shown in Fig. 2.
CORRECT POSTURE FOR MEASUREMENT
1. Open the battery cover and install four AA alkaline batteries in the
battery compartment as indicated. Ensure the polarity is correct;
Fig.1
Fig.2
Replace the batteries when the replacement indication “ ”appears in
the display or nothing after “ ” button is pressed;
Do not use rechargeable batteries;
Replace all batteries simultaneously;
If the device will be unused for a long period of time, remove the batteries;
DO NOT leave worn batteries in the device.
8
To Next Page
Loading...
Need help?
General