17
Connecting the cabinet
Read the text below thoroughly before electrical connection.
The cabinet is intended for connection to alternating current. The connection voltage (V)
and frequency (Hz) are shown on the name plate in the cabinet .
Power connection is made by a three pin plug to a wall socket.
Do not use the cabinet before all shieldings have been mounted to prevent access to live
or rotating machine parts.
Do not use the cabinet, if the wire has been damaged. In this case the cabinet must be
examined by a service electrician from Gram Commercial or an authorised refrigeration
company with knowledge of Gram’s products.
The cabinet must not be used outdoor. All earthing requirements stipulated by the local
electricity authorities must be observed. The cabinet plug and wall socket should then give
correct earthing. If necessary, contact an electrician.
Starting up
Display:
°C
°F
Alarm
Compressor
Defrost
Evaporator fan
Display
- key
+ key
P key
on/off
Connect the cabinet to main power.
To turn on the cabinet, push for 2 seconds.
The display shows the actual cabinet temperature, and indicates that power is connected.
The cabinet is turned off likewise, by pushing for 2 seconds.
To Next Page
Loading...
Need help?
General
