15
GB
16
17
Building into a kitchen ele-
ment
When building into a kitchen element
ensure that there is sufficient ventilation
around the refrigerator/freezer to dis-
sipate heat from the compressor. The
appliance can stand direct on the floor
or on its plinth. (16)
Building into a refrigerator el-
ement
Building into a refrigerator element fol-
lows the same principle as described
under 16. (17)
Electrical connection
The appliance is intended for connec-
tion to alternating current. The connec
-
tion values for voltage (V) and frequen-
cy (Hz) are given on the nameplate in
the cabinet. Power must be connected
via a wall socket with switch. The wall
socket should be easily accessible.
All earthing requirements stipulated by
the local electricity authority must be
observed. The appliance plug and wall
socket should then give correct earth-
ing. If in doubt, contact your local sup-
plier or an authorised electrician.
WARNING
The flexible cord (mains lead) fitted to
this appliance has three cores for use
with a 3-pin 13-amp or 3-pin 15-amp
plug. If a BS 1363 (13-amp) fused plug
is used, it should be fitted with a 13-
amp fuse.
To Next Page
Loading...
Need help?
General
