17
GB
Illustrations 18-25 show how easy it is
to change the doors from right-hinged
to left-hinged - or vice versa. (Changing
the door from left-hinged to right-hinged
is done in the same way, but opposite).
The refrigerator/freezer must
be switched off and emptied
completely.
· Remove the two screws in the
hinge top on the righthand side
of the cabinet. (18)
· Lift the refrigerator door slightly
and take the door and upper
hinge off by pulling the door
towards you.
· Remove the dummy hinge
from the opposite side by un-
screwing the two screws. (19)
· Reverse the dummy hinge and
refit it on the opposite side of
the cabinet using two screws.
· Remove the lower door by
unscrewing the two screws in
the centre hinge. (20)
· Refit the two screws from the
lefthand side on the righthand
side. (21)
· Lift the lower door and the cen-
tre hinge up and take them off.
· Tilt the refrigerator to an angle
of max. 45° and unscrew the
bottom hinge.
This is done by removing the
two screws holding the bottom
hinge on the cabinet under-
side. (22)
Remove the screws on the
righthand side of the door and
screw them onto the left side
of the door. Use the screws
from the left side to attach the
handles to the righthand edge
of the doors (25)
You can change the doors from right-
hinged to left-hinged or vice versa yourself
· Remove the bottom dummy
hinge in the opposite side in the
same way as the upper dummy
hinge was removed. (23)
· Reverse the dummy hinge and
refit it on the opposite side of
the cabinet.
· Reverse the upper righthand
hinge and refit it in the lower
lefthand corner of the cabinet.
· Place the cabinet in the verti-
cal position again.
· Dismount the door handle by
removing the screws. (24)
· Place the lower door in correct
position on the bottom hinge.
· Reverse the centre hinge, refit
it on the lower door and screw
it onto the cabinet. Remember
to adjust the hinges.
· Lift the top door into position on
the centre hinge. Reverse the
lower righthand hinge and refit
it on the top part of the door
in the left side of the cabinet.
Push the door into position and
slide the upper hinge into the
upper lefthand hinge casing.
Tighten the two screws. Re
-
member to adjust the hinges.
·
To Next Page
Loading...
Need help?
General
