Repair manual GRAMMER seat suspension MSG95EAC – November 2012
Material no. 1 277 338
Preface
Page 2 of 2
Bowden pull wires, cables and air hoses may only be fastened with cable ties at the
defined spots by hand (loose). Make sure that Bowden pull wires, cables and air
hoses cannot be squeezed or distorted when the seat suspension is adjusted and
the seat moved.
Replace all removed old parts with enclosed new ones. If there is no new part
included, the old one is to be cleaned and checked for its suitability for re-use.
Defective parts and worn parts must be replaced by new ones.
Grammer AG rejects any warranty claims if damaged or worn parts and assemblies
are not replaced by spare parts released by Grammer AG.
Qualified personnel
These instructions offer basic information on proper technical seat repair. The
contents of the work procedures described are intended for professionally educated
technicians with profound product knowledge. This level of knowledge is an
imperative requirement when performing the work and procedures described in this
document.
In order to avoid bodily injury, reduced operational safety of the seat suspension or
damage to it resulting from improperly performed work, all information and
instructions, in particular the safety instructions stated in Chapter 1, must be read
carefully and strictly observed.
As an inevitable matter of fact, GRAMMER AG cannot evaluate all situations and
consequences that may bear a risk of injury for the persons involved in the
described work procedures. For this reason it is absolutely necessary that every
person who carries out repair work at the seat suspension uses his/her professional
knowledge to make sure that his/her own safety will not be put at risk and that the
selected type of repair will not cause any negative effects, in particular with regard
to technical safety.
For this reason, GRAMMER AG disclaims liability for any possible damage of this
kind.
We point out explicitly that all work steps and procedures described are to be
performed with consideration to the applicable directives and regulations stipulated
by the relevant local authorities and in compliance with the provisions on health
protection, prevention of accidents and environmental protection.
Change notification and copyright
The seat suspensions are subject to continuous development. Please understand
that we must reserve the right to make changes in shape, equipment and technical
design. For this reason, the contents of this repair manual cannot be used to
substantiate any possible claims.
Reprint, translation and copies of this manual or parts thereof are admissible only
after written approval.
GRAMMER AG ⋅ Postfach 14 54
D-92204 Amberg
Phone +49 (0) 96 21 / 66-6822
www.grammer.com
Delivery and factory address:
GRAMMER AG
Köferinger Str. 9-13
D-92245 Kümmersbruck
To Next Page
Loading...