Repair manual GRAMMER seat suspension MSG95EAC – November 2012
Material no. 1 277 338
1.1 Safety instructions
Page 1 of 1
1 All inspection, test and repair work must be performed exclusively by adequately
trained personnel.
2 We point out explicitly that all work steps and procedures described are to be
performed with consideration to the applicable directives and regulations
stipulated by the relevant local authorities and in compliance with the provisions
on health protection, prevention of accidents and environmental protection.
3 Special notes in this repair manual are highlighted as follows:
WARNING ...
indicates possible risks for persons and their prevention.
ATTENTION ...
indicates possible damage or deterioration of material and their prevention.
Note: …
introduces an additional explanation for better understanding the work to be
carried out.
Installation note: ...
introduces an additional explanation for better understanding the installation
work to be carried out.
4 Before starting repair work, the following work has to be carried out:
• Disconnect the seat suspension from the power supply.
• Move the seat suspension to the end stops of the lower position.
5 When using oil, grease and other chemical substances, the relevant safety
regulations for the handling and use of these products must be observed.
To Next Page
Loading...