Grandstream Networks DP730 User Manual

DP Handset Menu Structure Definitions
BASIC OPERATIONS
Turning the Handsets ON / OFF
To turn ON the handsets
Long press on Power key until the LCD screen lights up.
To turn OFF the handsets
Long press on Power key again when the handset is idle until the display turns off.
Select a key [2], [3], [4], [5], [6], [7], [8] or [9] and press OK button. Select “Edit” to manually specify
the destination number or select “From Contacts” to select a contact as speed dial destination.
Call Features
● Do Not Disturb:Enable/disable do not disturb mode on the phone.
● Call Forward: Congure call forward feature.
● Call Waiting: Congure call waiting feature.
● Paging: Congures Inter-Handsets paging feature.
Status
● Base Status: Display Base status (Firmware, IP address, Subnet mask, Gateway, MAC Address)
● Handset Statut: Display Handsets status (Model RF, Firmware, IPEI)
● Line Status: Display Line status (Account name, Status)
Settings
● Handset Name:Change the Handset name.
● Phone Language: Select the language to be displayed on the phone’s LCD. (Default is English.)
● Date/Time: Congure date and time on the Handsets.
● Audio & Vibration: Specify ringtones for internal/external calls, the volume, advisory tones
(Keypad, Conrmation, Low battery notications), Handset TX Gain (-6dB, 0dB, +6dB), and
Vibration mode (DP730 only).
● Display: Congure backlight, LCD timeout (Idle/Call), LCD brightness, Message Waiting Prompt
and menu key timeout.
● Gestures (DP730 only): Congure Close-to-Ear Backlight and Facedown Hangup.
● Network Settings: Congure IP addresses and select DHCP/Static IP mode.
● SIP Settings: Congure/View SIP accounts settings.
● System Settings: Change Base PIN code, perform factory reset, reboot base and congure
repeater mode.
● Firmware Upgrade: Upgrade the rmware version of the Handsets.
● Factory Functions: Diagnostic Mode (DP722) / Keypad Diagnostic (DP730)
All LEDs will light up, and the LCD will display a table listing the names of all keys in red. Press any
key to diagnose; the key’s name will display in blue. After all keys are diagnosed, a prompt
message (“PASS”) will display; press “Back” (right softkey) to exit.
Note:User can long press arrow UP key to exit at any time.
● Audio Loopback: Speak to the phone using speaker/Handsets/headset. If you can hear your
voice, your audio is working ne. Press “Exit” softkey to exit audio loopback mode.
● LCD ON / OFF: Select this option to turn off LCD. Press any button to turn on LCD.
● LCD Diagnostic: Select this option to enter LCD Diagnostic mode. Press “Next” (left softkey) to
display white screen. Continue pressing the left softkey to view all remaining screens (black,
blue, red, and green) and then exit. End the test early by pressing the right softkey.
● LED Diagnostic: Enters this option and press “1” to start LED Diagnostic (you will notice that
the color of the LED will be changing). Press “2” to quit.
● System Monitoring: Displays RSSI, battery voltage and RPN information.
● Vibration (DP730 only): Test vibration on DP730.
● Acceleration Sensor (DP730):Displays X, Y, Z coordinates.
● Proximity Sensor (DP730): Test proximity sensor on DP730.

Grandstream Networks DP730 Specifications

General

Brand	Grandstream Networks
Model	DP730
Category	Cordless Telephone
Language	English