Grandstream Networks DP752 Administration Guide

P a g e | 101
DP752/DP730/DP722 Administration Guide
Version 1.0.11.4
Figure 41: Repeater Status – Associated (Auto Association)
Notes:
- For auto association, the option Use manually configured RFPI under DP760 Web GUI should
be disabled (by default disabled).
- The RF auto association requires the repeater to be close to the base during the pairing process
to work properly (this is a standard DECT repeater pairing limitation).
Manual Association
To manually associate your DP760 DECT Repeater to your DP752 Base Station:
1. Access the Web GUI of your DP760 using the admin’s username and password.
2. Navigate to DECT → General Settings and set Use Manually Configured RFPI to Yes.
3. On Manually Configured Base RFPI field, configure your DP752 Base Station RFPI address.
Note: The RFPI Address of your DP752 Base Station is available under the Web GUI → Status →
DECT Status → Base DECT RFPI Address.
4. Click Save and Apply to confirm the new settings.
5. Open subscription on your DP752 Base Station using one of following methods:
• Rebooting the Base station

Grandstream Networks DP752 Specifications

General

Device Type	DECT Base Station
Number of Handsets Supported	5
Concurrent Calls	5
Talk Time	Up to 20 hours
Standby Time	Up to 250 hours
Indoor Range	Up to 50 meters
Outdoor Range	Up to 300 meters
Compatibility	DP720, DP722, DP730
DECT Standards	DECT 6.0
Protocols	SIP (RFC 3261)
Network Interfaces	10/100 Mbps Ethernet (RJ45)
PoE	802.3af PoE
Voice Codecs	G.726
QoS	Yes
Security	SRTP, TLS
Firmware Upgrade	TFTP/HTTP/HTTPS
HD Audio	Yes