Grandstream Networks DP752 Administration Guide

P a g e | 103
DP752/DP730/DP722 Administration Guide
Version 1.0.11.4
Figure 43: Repeater Associated Status
❖ Associating DP760 using Repeater Management Mode on DP752
The repeater management mode displays discovered and paired devices using their name, IP and Mac
addresses and also gives the possibility of associating the DP752 Base Station with DP760 DECT Repeater.
Please refer to following steps in order to associate DP760 with DP752 using repeater management mode:
1. Access the Web GUI of your DP752 using the admin’s username and password.
2. Navigate to Status → DECT Repeater Status and select the repeater station from Discovered Devices.
3. Clink Link button to associate the base and repeater stations.
Note: The DP760 Repeater stations associated with DP752 Base Station are displayed and available under
Status → DECT Repeater Status → Paired Devices with their status, signal strength, number of active
calls and possibility to disconnect them from the paired base station.
Figure 44: DECT Repeater Status on DP752

Grandstream Networks DP752 Specifications

General

Device Type	DECT Base Station
Number of Handsets Supported	5
Concurrent Calls	5
Talk Time	Up to 20 hours
Standby Time	Up to 250 hours
Indoor Range	Up to 50 meters
Outdoor Range	Up to 300 meters
Compatibility	DP720, DP722, DP730
DECT Standards	DECT 6.0
Protocols	SIP (RFC 3261)
Network Interfaces	10/100 Mbps Ethernet (RJ45)
PoE	802.3af PoE
Voice Codecs	G.726
QoS	Yes
Security	SRTP, TLS
Firmware Upgrade	TFTP/HTTP/HTTPS
HD Audio	Yes