Grandstream Networks GDS3710 - Figure 15: Region Config; Motion Detection; Table 3: Motion Detection

P a g e | 16
GDS3710 Input/output Alarms
Configuration Guide
Motion Detection
Users can select a specific region to trigger the alarm using motion detection.
Figure 15: Region Config
Table 3: Motion Detection
Enable Motion Detection
Click on the check box to enable Motion Detection.
Region Config
Click to enter the Region Config menu.
Quit Config
Click to exit the Region Config menu.
Clear Selected Region
Select a zone on the screen then click on Clear to delete the region.
Sensitivity
Region sensitivity (value between 0-100%).
Select Alarm Schedule
Select the Schedule programmed.
Select Alarm Action Profile
Select the programmed Alarm Action.