P a g e | 91
GRP261x/GRP2624/GRP2634 Administration Guide
Version 1.0.5.48
Network Page Definitions
Table 13: Network Page Definitions
Selects “IPv4 Only”, “IPv6 Only”, “Both, prefer IPv4” or “Both, prefer IPv6”.
The default setting is “IPv4 only”.
Allows users to configure the appropriate network settings on the phone to
obtain IPv4 address. Users could select “DHCP”, “Static IP” or “PPPoE”. By
default, it is set to “DHCP”.
Specifies the name of the client. This field is optional but may be required by
some Internet Service Providers.
DHCP Vendor Class
ID
(Option 60)
Used by clients and servers to exchange vendor class ID.
The default setting is “Grandstream GRP2612” for GRP2612, “Grandstream
GRP2612P” for GRP2612P, “Grandstream GRP2612W” for GRP2612W,
“Grandstream GRP2613” for GRP2613, “Grandstream GRP2614” for
GRP2614, “Grandstream GRP2615” for GRP2615 and “Grandstream
GRP2616” for GRP2616.
Enter the PPPoE account ID.
Enter the PPPoE Password.
Enter the PPPoE Service Name.
Enter the IP address when static IP is used.
Enter the Subnet Mask when static IP is used for IPv4.
Enter the Default Gateway when static IP is used for IPv4.
Enter the DNS Server 1 when static IP is used for IPv4.
Enter the DNS Server 2 when static IP is used for IPv4.
Enters the Preferred DNS Server for Ipv4.
Allows users to configure the appropriate network settings on the phone to
obtain IPv6 address. Users could select “Auto-configured” or “Statically
configured” for the IPv6 address type.
Enter the static IPv6 address when Full Static is used in “Statically configured”
Ipv6 address type.
Enter the IPv6 prefix length when Full Static is used in “Statically configured”
Ipv6 address type.
Enter the IPv6 Prefix (64 bits) when Prefix Static is used in “Statically
configured” IPv6 address type.
Enter the DNS Server 1 for IPv6.
Enter the DNS Server 2 for IPv6.
To Next Page
Loading...
Need help?
General
