Load the test sheet to perform the first automated cut.
Turn on the plotter and the feeder.
Press the key 2 on the plotter panel.
If the plotter is set correctly, the cutting head moves left and right.
It has to stop near the left pinch roller.
On the software press the button ‘File Open’
Load the file label_test_contour_32x45.ai
If the system is correctly connected you see a green checkmark
on the bottom right of the window.
Insert the value 53 on the edit box ‘First Marker’
Press the button ‘Cut Test’ to perform the first cut.
The feeder load the sheet, each black mark stops under the camera
for detection and then start the cutting operation.
After the job have finished you can check the print-cut aligmnent.
You may have to follow the procedure on the next chapter for
a perfect alignemt.
Turn on the plotter
main switch on the
left side.
Turn on the plotter
main switch on the
left side.
Slide the feeder to the
SA3 line on the label.
When you turn on the F-Mark feeder, it performs an initialization cycle.
The arms moves up and down once until it stops in stand by position.
A red light appears on the switch button.
Rise the media leverPress key 2 on the panel
Cut the first test sheet.
To Next Page
Loading...
