GRAPHTEC F-Mark - Safety Precautions

Safety Precautions
WARNING
Indicates a potentially hazardous situation
which, if not avoided, could result in death
or serious injuries.
Follow these guidelines to avoid the risk of fire, burns, injury,
electric shocks, rupture, overheating, abnormal odours or smoke.
Always use the recommended AC adapter (EA10682U-120) for the
ddCutter feeder to prevent any damage or failure.
The rated voltage is 110-240V AC 50-60Hz.
Do not touch the F-Mark device during a lightning storm.
Do not use the machine / AC adapter in places of high humidity
Do not overload the power cord.
Do not place heavy objects on, or damage the power cord or plug. Do
not forcibly bend or pull the power cord.
Make sure that the plug is fully inserted in the power outlet. Do not use
an outlet that is loose.
Do not allow the machine / AC adapter / power plug to get wet for
example, by handling them with wet hands or spilling beverages onto
them.
Do not disassemble or modify the F-Mark / AC adapter.
Disconnect the AC adapter and stop using the machine if you notice
abnormal odour, heat, discolouration, deformation or anything
unusual while using it.
CAUTION
Indicates a potentially hazardous situation
which, if not avoided, could result in minor
or moderate injury.
Follow these guidelines to avoid the risk of, injury, electric shocks,
or damages to the ddCutter.
When placing the F-Mark device, allow enough table space, take in
consideration the vibrations generated during operations.
Ignoring to do this might cause the product or part of it to fall out of
position, resulting in possible body injury or malfunction of the
product.
Don not use or store the product is exposed to direct sunlight, water
or oil splashes, salty air or saltwater, dust or humidity, flamable gas.
Do not touch the paper sheets duting operation, the paper edge can
cut seriously your skin.
Do not approch with your face to the moving arm and moving paper
sheets.
Do not attempt to lubricate the mechanisms.
Do not apply force or object weights on the moving arm.
Lay the power adapter in a position so the green light is visible.
This will alert if the adapter should accidentally go off due to external
effects. If for any reason the green light goes off, disconnect the AC
power cord from the wall.
Be sure to grasp the plug, not the cable, when disconnecting the
power supply from an electric socket.
1