GRAPHTEC gl200 - Disassembling the Top Cover and the Bottom Case Assembly

GL200-UM-251-9370 3-2
3. DISASSEMBLY AND REASSEMBLY
3.3 Disassembling the Top Cover and the Bottom Case Assembly
Disassembly
(1) Remove the side pads from the main unit (See Section 3.2).
(2) Remove the four M2L8 self-tapping screws from the bottom cover.
(3) Disconnect the connector between the main control board and the AMP board and then remove the top
cover assembly.
M2L8 self-tapping screw
Bottom case assembly
Top cover assembly
Re-assembly
(1) Re-assemble the top cover assembly and the bottom case assembly in the reverse order in which they
were disassembled.