GRAPHTEC gl200 - AC Line Cycle Setting

GL200-UM-251-9370 4-4
4. SETUP PROCEDURES
4.2 AC Line cycle Setting
You must set the AC Line cycle setting of the GL200/A to the same cycle as that of your AC line before you
perform the Setup1 and Setup2 operations.
How to set the AC line cycle
(1) Press the [MENU] key until the "OTHR" menu shown below appears.
(2) Move the cursor to the "AC Line cycle" position using the [Direction] keys.
(3) Press the [ENTER] key to display the "AC Line cycle" selection menu shown below.
(4) Select the appropriate cycle for your AC line.