76
RollCall Control Panel
RollTrack
•The third set, 01, is the slot number in the unit.
• The fourth set, 99, is a user-definable number that is a unique identifier for the destination
unit in a multi-unit system. This ensures only the correct unit will respond to the command.
If left at 00, an incorrectly fitted unit may respond inappropriately.
RollTrack Command
This item enables a command to be sent to the selected destination unit.
The command may be changed by typing a code in to the text field, and then selecting S to
save the selection. Clicking P returns to the default preset command.
A RollTrack command consists of two sets of numbers, for example: 84:156:
• The first number, 84, is the actual RollTrack command.
• The second number, 156, is the value sent with the RollTrack command.
RollTrack Sending
A message is displayed here when the unit is actively sending a RollTrack command. Possible
messages are:
RollTrack Status
A message is displayed here to indicate the status of the currently selected RollTrack index.
Possible RollTrack Status messages are:
Log Field Description
No The message is not being sent.
Yes The message is being sent.
Log Field Description
OK RollTrack message was sent and received successfully.
Unknown RollTrack message has been sent but transmission has not yet
completed.
Timeout RollTrack message has been sent but acknowledgment not received.
This could be because the destination unit is not at the location
specified.
Bad RollTrack message has not been correctly acknowledged at the
destination unit. This could be because the destination unit is not of
the type specified.
Disabled RollTrack sending is disabled.
To Next Page
Loading...
