GRAUPNER Twister - TWISTER Required Accessories; Motor and Radio Control System; Internal Combustion Engine Parts

GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
We reserve the right to introduce modifications. Not liable for printing errors! 12/2011
Made in Vietnam
3
The extensively pre-fabricated model can be built in a very short time.
However, the remaining steps are important and have to be carried out with
care. Doing this work properly determines whether the model will have the
prescribed rigidity and flight characteristics; so please work slowly and
precisely!
When putting screws into wood, apply a little casein glue to keep them from
loosening: Squirt casein glue into the drill hole and screw in the screw. All
metal bolts and nuts should be secured against loosening with thread lock
fluid, such as "UHU schraubensicher."
Other required accessories
Motor and accessories
Motor
Order No.
Drive battery
Order No.
Speed
controller
Order No.
Propeller
Order No.
OS MAX 95 AX including
silencer 2749
1314.13x8
OS Motor OMA-5025-375
6627
9733.5 or
9733.3 *
7236 1328.40.25
* 2 required
Radio control system
It must have at least 6 channels and 10 servos. Furthermore, the transmitter
must be capable of servo rotation reversal.
Particularly recommended: computer system starting with MX-16 to mc-24. For
rudder, landing flaps, and retractable undercarriage, servos with a width of 13 mm
and about 54 Ncm are called for, such as Order No. 7931.
Each of the two aileron servo cables, needs an extension cable, Order No. 3935.32
to extend them.
For rudder, elevators, and engine throttle, servos with standard dimensions, such as
Order No. 7950 are used.
As receiver battery, we recommend: LiPo 2/1600 Order No. 9717.2 in connection
with the ON/OFF switch PRX 3A Order No. 4135, which has to be carefully serviced
before and after all flight operations.
In this regard, see also the instructions for the RC system, batteries, et cetera.
To connect the servos for ailerons, airbrakes, and retractable undercarriage,
insert the 180 mm extension cable into the corresponding socket on the receiver. To
store the receiver and battery, for example cellular cauoutchouc (rubber), Order No.
1637 is needed.
Adhesives
Casein glue, for example UHU coll, Order No. 958.60
UHU hart, for example Order No. 534.35
Fast setting glue, for example Order No. 5822
Thread lock fluid, for example Order No. 952
Accessories for operation with internal combustion engine (not included)