GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
We reserve the right to introduce modifications. Not liable for printing errors! 12/2011
Made in
Vietnam
4
Fuel with synthetic oil, depending on the motor used
Fuel filter, for example Order No. 1650.1
Fuel hose, for example Order No. 1643
Manual fuel pump, for example Order No. 1610
Spark plug battery with spark plug clip, for example Order No. 3253
Electric starter, for example Order No. 1628
Starter battery for example Order No. 2592
Accessories for operation with electric motor (see table)
Chargers, see main catalogue FS
Required tools (not included)
Various (Philips) screwdrivers, flat-nose pliers, wire cutter, balsa knife or razor blade,
various drills, universal spark plug wrench, soldering iron, various Allen wrenches.
Do not begin the assembly until you have familiarised yourself well with the
components and the individual construction stages. If you are not satisfied with any
component, report it to your retailer before you start the construction process.
Assembling the TWISTER
The wing halves
The servo lever, Order No. 3544, as shown in the photo, needs to be shortened on
one side and, with the servo in the centre position, mounted on the drive shaft of the
servo, or 7907.1 can be used.
Place the servos in the centre position using the receiver system. Fasten the servo to
the attachment blocks using the screws included with the servos. To do so, insert the
rubber grommets with the brass hollow rivets, collar downward, into the servo flange.
For drilling Ø 1.5 mm holes for the screws, the hollow rivets can be used as a drilling
template. To make it easier to push them in, the hollow rivets can be placed onto a
screwdriver of the proper size.
To Next Page
Loading...
