GRAUPNER ULTRAMAT 16 - Charge and Discharge Programs

28
7. Program flowchart
6. Charge and discharge programs
The various facilities of the charger are divided up into four program groups which you can select by
holding the MODE button pressed in for two seconds. The sequence is shown in the flow chart
below.
Ni-Cd battery programs: charging, conditioning, discharging to determine capacity or residual
capacity, or to select cells.
Ni-MH battery programs: charging, conditioning, discharging to determine capacity or residual
capacity, or to select cells.
LiPo / LiIo / LiFe battery programs: charging, discharging to determine capacity or residual capacity,
or to select cells.
Lead-acid battery programs: charging, discharging to determine capacity or residual capacity, trickle
charge for stand-by operation.
NiCd
AUTOMATIC-
program
NiCd
MANUAL-
program
NiCd
discharge
program
NiCd
cycle
program
NiMH
AUTOMATIC-
program
NiMH
cycle
program
NiMH
MANUAL-
program
Pb
MANUAL-
program
Pb
discharge
program
Lithium
MANUAL-
program
Lithium
discharge
program
NiMH
discharge
program
Lithium
type
select
NiCd
∆ ∆
∆ ∆
∆ delta-peak
trigger voltage
NiMH
∆ ∆
∆ ∆
∆ delta-peak
trigger voltage
MODE MODE MODE MODE MODE
MODE MODE MODE MODE MODE
MODE MODE MODE
MODE MODE
MODE (2 sec.)
MODE (2 sec.)
MODE (2 sec.)
MODE
(2 sec.)
MODE
(2 sec.)
MODE
(2 sec.)
MODE
(2 sec.)
MODE
NiCd
discharge balancing
program
MODE (2 sec.)
MODE
NiMH
discharge balancing
program