7.
8.
L
r0.
11.
Separate wirilg harness at connector(s).
Remove ths bolts securing the
rear hitc}
to the engine oil base. Swing rear hitch
to one side.
Remove
the two top bolts securing the
elgine to the chassis. Replace
with
two studs.
Remove
the twc lower bolts securing the engine to the chassis.
Slide
engine bac& off
chassis.
Figure 2I Figvre 22
Transmission Drive
Gear
iemoval
A
gear
puller
must be
used to remove
the
gears
from the crankshaft.
f,ngine Adapter Plate
The
engine adapter
plate
is
secured to the engine crankcase
with 4 %-inch br:lts.
Remove bolts aad then
re-
move
adaptor plate.
I
NSPICTIOH.DISASSEiNBIY
1{&ea disassemrbling
an engine, carefully inspect and noie the
physical
apir*aratre of each of the coqpon-
ents.
Ofte* tfie apgre*:arce
of
park
will
in&cate operation
under other rlran idesl
coa&tioos.
Ia
observing these
iniietors,
ysu
may
be *ble to sugg€st
improved renrice and operattng
tmtrniques wbich
ndll rerult in
prolongod
engino
sernie
li[e.
Some
al tlrt thirgs to look for arer
L 9xtesslve
sludge
and varuish Iormation.
g.
Scoriug oi tle cylinder walls.
gT
To Next Page
Loading...
