EN - 13
5. Rotate ROPS to operating position and
secure with lock pins. Secure lock pins
with hairpins. See Figure 7.
6. Remove two eccentric spacers, two
round head square neck bolts and two
locking nuts from hardware bag.
7. Rotate steering levers to operating
position and install eccentric spacer
between steering lever plates. Secure
with hardware. See Figure 8.
8. Adjust steering levers. See Adjust
Steering Levers on page 33.
9. Check tire pressures and inflate to
recommendation. See Check Tire
Pressure on page 26 and see
Specifications on page 45.
10. Remove battery from unit and charge.
See Charge Battery on page 29.
11. Make sure deck is level. See Level and
Pitch Mower Deck on page 39.
12. Ensure all hardware is tight.
Figure 7
1. ROPS
2. Lock Pin
3. Hairpin
1
2
3
Figure 8
1. Eccentric Spacer
2. Steering Lever
3. Steering Lever Plate
1
2
3
To Next Page
Loading...
